Every homeowner desires uninterrupted daily life but lacks an appliance maintenance routine. The lifespan of your appliances is crucial for the smooth flow of daily activities in the house. However, lack of regular maintenance leads to daily hassle. Consulting an HVAC company in Sacramento can help you save money in the long run. Checking that your water heater is functioning ensures that your home uses energy and water efficiently. Over time things like lime, calcium, and other minerals accumulate in the base of your water heater. As a result, your water heater works harder to heat the water for your home and reduces lifespan. The best way to get rid of that mineral build-up is to clean your water heater.
Here Is How You Clean A Water Heater:
Turn It Off
Switch the power off if your water heater is electric. Set your thermostat to “pilot” if your water heater is a gas heater. This turns off your water heater’s heating element, allowing the water to cool.
Drain The Tank
Switch off the cold water valve to empty your tank of water. If you skip this step, water will keep flowing into the tank and draining, which might significantly increase your water bill. Place a bucket below the drain valve. Next, join the valve with the end of a garden hose. Place the hose’s other end next to a floor drain, a sink, or, if it’s long enough, outside. To release the contents of the tank, open the valve.
Refill The Tank
Refill the tank with cold water to lose the remaining sediment. This step is important if you have hard water running in your area because hard water contains dissolved minerals and creates low water pressure problems.
Brush It Off and Flush
You can also brush the interior lining of your tank to remove more sediment. You can use refrigerator coils to clean the interior lining. Next, you remove the drain valve to let the brush in. Gently scrape the hardened minerals at the bottom and the lower sides. A refrigerator coil is an effective tool for cleaning the interiors of the tank. Flush the tank one last time to ensure proper cleaning.
After draining the tank, turn off the drain valve, switch on the cold water and let the tank fill. Turn on your water heater. Your water heater is ready to function again. Sometimes, cleaning is not enough because of excessive wear and tear. You can consult an expert for a new water heater installation in Sacramento.
Conclusion
Water heater flushing is important because sediment build-up will cause problems, affecting your daily life. Failure of components like clogged pipes or the heating element, loss of heating power, and potential health problems for those who consume the water can all be caused by letting sediments and calcium deposits build up in the tank.
